Collapsed Drain Liner Removal
Be it a collapsed or poorly installed liner, at Drain 365 ltd we have the equipment to re-bore the pipe line, removing the drain liner. This is carried out using a unique cyclone cutting attachment. From time to time drain liner will go wrong, this will happen to the best of us. This is normally due to water penetration or human error.
The typical defects found with liner installations are:
LINER HAS NOT OPENED CORRECTLY
RESIN WASHED OUT DURING INSTALLATION
LINER WINKLED OR DEFORMED DURING INSTALL
ROUGH FINISH TO LINER WALLS OR ENDS
ROOT PENATRATION THROUGH LINER
All these can be repaired without the need for expensive excavation works. At Drain 365 Ltd with have the correct solution for these problems.
Cutting and grinding is the most effective solution if a liner is wrinkled, deformed or has debris trapped under it. The Drain 365's unique equipment is the solution to your problem. How this works is we would insert a cable with a cutting and grinding attachment, this would then remove the problem section of liner. Once the section has been removed we would then carry out a repair using an epoxy patch repair.
This process works the same for cleaning up poorly installed liner ends. We would cut back the 1st or last 300mm of drain liner using the unique machine. Once the ends had been removed an epoxy patch repair would be installed to finish off and make water tight the ends.
Before any of the above works can be carried out, we would need to carry out a drain inspection. This would be carried out by a fully trainer Drain 365 Ltd engineer. From this we would then compile a fully report with the most cost effective solution to the problem.
Blocked Drain - Drain Repair - CCTV Survey
Drain Clearance - High Pressure Jetting
24/7 EMERGENCY CALL OUT SERVICE
LONDON - HERTFORDSHIRE - BEDFORDSHIRE - BUCKINGHAMSHIRE